Ice-Maker Repair in Denver

Ice-Maker Repair

The ice-maker is a great invention, which we usually take for granted, even during the hottest days of summer. It helps us to keep fresh ice on hand for everyday use. If something goes wrong with your appliance, do not get upset. Call Denver Appliance Repair at (303) 200-9921 to schedule a service appointment and we will get your ice-maker working properly again as soon as possible.
Here are some of the most common ice-maker problems and the most probable causes of it:

Ice-maker not working

Temperature Is Too Low
Defective Water Inlet Valve
Low Water Pressure
Temperature Is Too Low

Temperature Is Too Low

The ice-maker will not produce ice cubes efficiently if the freezer temperature is too high. Ideally, the temperature should be set between 0 and 5° F or -18 and -13° C. If the freezer temperature stays above 15° F, there is probably something wrong with the appliances cooling system. This can be caused by accumulated debris on the condenser coils, preventing the coils from properly dissipating heat. The failure of the condenser fan motor to properly circulate the air, or frosted over evaporator coils restricting airflow. The evaporator coils being frosted over, indicates a failure in the defrost system, which is caused by a defective defrost control, heater or thermostat.

Defective Water Inlet Valve

Defective Water Inlet Valve

The refrigerator’s water inlet valve controls the water being sent to the icemaker tray. The inlet valve can fail both mechanically and electrically. A mechanical failure could be caused by the build-up of mineral deposits, preventing the valve from opening. If this happens, you will need to replace the valve. Trying to clean out an old valve is not recommended due to the risk of part failure after repair. To determine if the inlet valve has failed electrically, use a multi-meter to test the valve solenoid coils for continuity. If one or more of the coils tests negative for continuity, the inlet valve will need to be replaced.

Low Water Pressure

Low Water Pressure

To operate properly, the water inlet valve requires between 20 and 120 PSI. To help determine this, shut off the water supply, disconnect the supply line from the inlet valve and hold the line over a bucket. Turn the water supply back on, in a serve whether or not there is a strong flow of water jetting out of the line. A weak flow indicates a problem with the water line or the water supply valve.

Looking for Professional Repair?

Call (303) 200-9921 from 8 AM to 8 PM, seven days a week, to request an appointment.